1月 « 2021 « ACS NEWS

2021年、明けましておめでとうございます。
正月休み明け、気付いたら2020年大晦日に Rev368 がリリースされていました。

2020/12/31
==========
1) Added new PATTERNCOMPONENT PV (pressure*velocity)
   in the PATTERN post-processing menu. PV is
   frequently used as a metric for scuffing failure.

2) Corrected contact result scripts. They had a mistake
   in the calculation of grid length, so their load-
   intensity was incorrect.

3) Added extra clearance parameter for contact between
   TIP and ROOT of SUN and RING gears

4) Added feature to specify NODESET for imported
   housing/carrier races. 

5) Added feature to apply taper error on journal bearing races

6) Added feature to apply deflection/force at master nodes of 
   condensed housing

7) Added two new templates THINRIMTIP.TPL, and
   THINRIMFINEROOTTIP.TPL. Use the templates *TIP.TPL
   when modeling tip contact in involute gears. These
   new templates generate a correct cylindrical
   surface at the tip.

8) Relaxed the check for root-tip interference for
   conformal SUN-RING gear pairs. This allows the
   modeling of interference effects without error messages.

9) Added an new error message to be triggered when
   using modification files with imported hypoid mesh files.
   The error message is emitted if a modification file
   is used, but the REGENERATE flag is turned off.

10)Added script for obtaining pinion-shaft deflection
   data, postpinionshaftdeflection.cmd.

11)Corrected the rotor shaft deflection script
   postshaftdeflection.cmd. It was crashing when an
   imported FE mesh is used in a rotor shaft.

12)Added LIMIT_THINWALL_CIRCORDER to PINIONSHAFT and
   PINSHAFT (for helical pinions).

13)Increased the max value for NAXIALDIVS of the roller
   bearings to 128. 

14)Corrected Transmission3D users manual. The links
   and table of contents were broken.

15)Bug fix to manufacturing errors of SHAFT segment. 

16)Bug fix - FaceHobbed Hypoid mesh generator with
   straight TOPREM 

17)Bug Fix: Extra clearance for SUNTIP_ROTORSHAFT and
   RINGTIP_ROTORSHAFT was not applied correctly. 

18)Bug Fix: Hypoid mesh generator with CMM modification
   was incorrectly processing measured points that
   were not found on the surface of the tooth.