日本時間 5月29日、ANSOL T3D Rev353が出ました。
モジュールは、HP Install/TM3D/Rev353_190528 にアップしてあります。
＜リリースノート＞
Rev: 353
Author: sandeep
Last modification:Rev 353 - 2019-05-28 16:03:23 -0400 (Tue, 28 May 2019)
Log message: 2019/05/28
==========
1) Added the USE_LOCAL_FIELD option to the EXPORTFERESULTS,
FATIGUE and SEARCHSTRESS menus. In the FATIGUE and SEARCHSTRESS
menus, when this flag is turned OFF, stress is zeroed out for
samples within distance DISTMIN of a contact point. If it is turned ON,
then the local field is used instead. In the EXPORTFERESULTS menu,
stresses are not zeroed out, pure FE stresses are used instead.
2) The stress data written to the OES table, and displacement
data written to an OUG table of an OP2 file were not
compatible with the Patran OP2 reader. Now the OUG and OES
data reads correctly into Patran as well as HyperView.
以前のOP2ファイルは、一部POSTで表示できないことがありましたが、
今回の改良で修正されました。
3) Added implementation of cylindrical surfaces for a
contact PAIR of type CARRIER-CARRIER.
4) Added ability to read the Rayleigh damping constants
Alpha and Beta from the *DAMPING commabnd inside an
Abaqus file. For a Nastran file, the coefficients are
read from PARAM,ALPHA1,RayleighAlphaValue and
PARAM,ALPHA2,RayleighBetaValue cards inside
the BULKDATA section.
5) Changed the name of the Guide shortcut from
Guide to T3DGuide. This is to remove conflicts when
other software modules that also use Guide are
installed on the same machine.
